honda — Power Trim/Tilt Assembly

g. STERN BRACKET/SWIVEL CASE/POWER TRIM/ TILT ASSEMBLY INSTALLATION [1] SWIVEL CASE BUSHING (2) [2] SWIVEL CASE ASSEMBLY Check that the piston rod of the power trim/tilt assembly is in the fully extended position. [3] TILTING SHAFT 1) Apply grease to the inner wall and circumference of the new swivel case bushings. Install the new swivel case bushings on the swivel case. [4] TILTING BOLT CAP 2) Apply grease to the new 15.54 x 2.26 mm O-ring and install it in the groove in the tilting shaft. Apply grease to the threads and bearing of the tilting shaft. Apply grease to the shaft installation parts of the swivel case assembly and of the L./R. stern brackets.

[5] 7/8-14 UNF SELF-LOCKING NUT 3) Tighten the new 25 x 2.5 mm self-locking nut or the 7/8-14 UNF self-locking nut on the threads at either the right or left end of the tilting shaft. [6] 15.54 x 2.26 mm O-RING 4) Apply grease to the entire surface of the 26 mm wave washer. Install the stern bracket and the 26 mm wave washer on the end of the tilting shaft where the self-locking nut has been mounted. [7] R. STERN BRACKET [11] WIRE HARNESS CLIP When the 7/8-14 UNF self-locking nut has been tightened on the tilting shaft, insert the tilting shaft into the R. stern bracket. [8] 26 mm WAVE WASHER (2) [10] L.

STERN BRACKET [9] 25 x 2.0 mm SELF- LOCKING NUT 5) Pass the tilting shaft through the swivel case assembly and install the 26 mm wave washer and the stern bracket. 6) Loosely tighten the new 25 x 2.0 mm self-locking nut or the 7/8-24 UNF self-locking nut on the tilting shaft. Move the L./R. stern brackets to the self-locking nut side. Raise the swivel case assembly to the uppermost position and hold it in the position with the tilt stopper. Install the wire harness clip on the L. stern bracket. 7) Apply grease to the inner wall and circumference of the new lower cylinder bushings and install them on the power trim/tilt assembly.

[1] POWER TRIM/TILT ASSEMBLY Apply grease to the circumference of the lower cylinder collar and install it in the power trim/tilt assembly. [2] LOWER CYLINDER COLLAR Apply grease to the entire surface of the 26 mm wave washers and install them on the power trim/tilt assembly. 8) Pass the trim angle sensor wire, power tilt motor wire and the speed sensor tube B through the hole in the L. stern bracket. 9) Install the lower cylinder collar, that has been mounted in the power trim/tilt assembly, on the L./R. stern brackets. [4] LOWER CYLINDER BUSHING (2) [3] 32 mm WAVE WASHER (2) 15-30