honda — Power Trim/Tilt Assembly

15) Remove the swivel case assembly and the special tool from the hydraulic press. [1] 39 mm EXTERNAL CIRCLIP [2] PART “A” 16) Check that the mount frame turns smoothly. Check that the 39 mm external circlip sets in position smoothly. Install the 39 mm external circlip and apply grease to the part “A” shown in the drawing. smoothly> [4] PRESS [3] DRIVER 07749-0010000 (1) Attach the special tools to the lower mount center housing. [5] ATTACHMENT, 32 x 35 mm 07746-0010100 TOOLS:

Driver 07749-0010000 Attachment, 32 x 35 mm 07746-0010100 Pilot, 30 mm 07746-0040700 (2) Tighten the puller bolt and align the surface of the lower mount center housing with the circlip installation groove in the mount frame. Remove the puller and the special tool. (3) Install the 39 mm external circlip and apply grease to the part “A” shown in the drawing. [6] LOWER MOUNT CENTER HOUSING OF MOUNT FRAME 17) Tighten the 6 x 8 mm screw while pushing the ground cable against the projection of the lower mount center housing. [1] Push against the projection. [2] 6 x 8 mm SCREW 18) After assembling the swivel case, fill the grease fittings with the grease using a grease gun.

[4] GROUND CABLE [3] LOWER MOUNT CENTER HOUSING 15-29 [7] PILOT, 07746-0 30 mm 040700 [8] CIRCLIP INSTALLATIO GROOVE [9] ENLARGED VIE 9] NLARGED VIE