honda — Power Trim/Tilt Assembly

12) Apply grease to the spline of the lower mount center housing. [1] “ ” MARK [2] MOUNT FRAME Install the lower mount center housing on the mount frame aligning the “ ” mark on the lower center housing with the mark on the mount frame that had been put during disassembly. [3] MARK [4] LOWER MOUNT CENTER HOUSING 13) Position the swivel case/mount frame on the hydraulic press as shown. 14) Position the special tool on the lower mount center housing as shown. [1] DRIVER, 40 mm I.D. 07746-0030100 Press fit the lower mount center housing until it contacts the swivel case (i.e. hydraulic pressure of the hydraulic press rises slightly). TOOL: Driver, 40 mm I.D.

07746-0030100 [2] LOWER MOUNT CENTER HOUSING 15-28