honda — Power Trim/Tilt Assembly

13) Check that the corrugated tube on the power tilt motor wire stands erect as shown. [1] CORRUGATED TUBE (It must stand erect.) [2] POWER TILT MOTOR WIRE 14) Clamp the speed sensor tube B with the two speed sensor tube plates and loosely tighten the two 6 x 8 mm screws. [2] 6 x 8 mm SCREW (2) [3] SPEED SENSOR TUBE PLATE (2) 15) Tighten the 6 x 8 mm screw securely so that the distance from the gear case side speed sensor tube end to the end of the speed sensor tube plate is 15 – 20 mm (0.6 – 0.8 in) as shown. Route the speed sensor tube B on the L. stern bracket and tighten the 6 x 8 mm screw of the upper speed sensor tube plate securely.

[1] SPEED SENSOR TUBE B 16) Connect the speed sensor tube A to the joint A and fasten the new wire band on the speed sensor tube A. [1] MOTOR WIRE BUSHING [3] SPEED SENSOR TUBE A Connect the speed sensor tube B to the joint A and fasten the new wire band on the speed sensor tube B. [2] WIRE BANDS 17) Adjust the distance from the end of the motor wire bushing to the end of the speed sensor tube B so that it is 10 – 15 mm (0.4 – 0.6 in) as shown. [4] JOINT A [5] SPEED SENSOR TUBE B 10 – 15 mm (0.4 – 0.6 in) 15-32 15 – 20 m (0.6 – 0.8 m in