honda — Power Trim/Tilt Assembly

18) Wind the spiral tube around the trim angle sensor wire, power tilt motor wire and the speed sensor tube A. [1] SPIRAL TUBE 19) Align the taped end of the power tilt motor wire with the end of the motor wire bushing and install. Clamp the trim angle sensor wire, power tilt motor wire and the speed sensor tube A with the wire harness clip. Avoid clamping on the spiral tube. [8] WIRE HARNESS CLIP [2] TRIM ANGLE SENSOR WIRE [3] MOTOR WIRE BUSHING [7] SPEED SENSOR TUBE A [6] POWER TILT MOTOR WIRE [4] L. STERN BRACKET [5] TAPE 20) Pass the trim angle sensor wire, power tilt motor wire and the speed sensor tube A through the undercase grommet C.

[3] POWER TILT MOTOR WIRE [2] TRIM ANGLE SENSOR WIRE 21) Align the taped ends of the trim angle sensor wire and the power tilt motor wire with the end of the undercase grommet C, and fasten the new wire band as shown. After fastening the wire band, cut the excess of the wire band so that the projected length is 5 – 10 mm (0.2 – 0.4 in) (P. 2-44). [1] SPEED SENSOR TUBE A [4] TAPED PARTS [5] WIRE BAND [6] UNDERCASE GROMMET C 15-33