22) Apply grease to the inner wall and circumference of the new upper cylinder bushings and install them on the piston rod of the power trim/tilt assembly. 23) Apply grease to the circumference of the upper cylinder pin. 24) Align the hole in the piston rod with the hole in the swivel case assembly and insert the upper cylinder pin into the swivel case assembly. Install the two 15 mm E-rings on the upper cylinder pin. [3] SWIVEL CASE ASSEMBLY [2] UPPER CYLINDER PIN [1] 15 mm E-RING (2) [5] UPPER CYLINDER BUSHING (2) [4] PISTON ROD 25) Insert the 10 x 235 mm hex. bolt from the L. stern bracket side and set the 10 mm washer. Tighten the 10 mm self-locking nut to the specified torque.
[1] 10 mm SELF- LOCKING NUT TORQUE: 34 N . m (3.5 kgf . m, 25 lbf . ft) [2] 10 mm WASHER [3] 10 x 235 mm HEX. BOLT 15-34