honda — Power Trim/Tilt Assembly

26) Check the anode metal for corrosion and replace with a new one if necessary. Tighten the anode metal with the two 6 x 25 mm hex. bolts securely. [2] 6 mm WASHER (2) [1] ANODE METAL [3] 6 x 25 mm HEX. BOLT (2) 27) If the manual valve is tightened, loosen it fully. Raise the swivel case assembly a little, unlock the tilt stopper and lower the swivel case assembly to the lowermost position. 28) Remove the following parts. – Stern bracket/swivel case (P. 15-12) – Gear case assembly (P. 14-5 and 44) – L./R. engine under covers (P. 4-14) – Engine cover (P. 4-2) [1] MANUAL VALVE 15-35