4. POWER TRIM/TILT ASSEMBLY a. REMOVAL Remove the stern bracket, swivel case and the power trim/tilt assembly (P. 15-14). b. DISASSEMBLY Do not reuse the O-rings. Do not try to disassemble the pump assembly. Replace the pump assembly as an assembly if it is faulty. Do not use a shop towel or equivalent cloth, and do not wear the gloves during this operation. Do not reuse the drained Automatic Transmission Fluid (ATF). When the operation is made by holding the cylinder comp. in a vice, do not tighten the vice excessively. It can damage the cylinder comp.
Clean the disassembled parts with the fresh Automatic Transmission Fluid (ATF) and blow the parts with compressed air to remove dust and dirt. Store the parts neatly keeping them off dust, dirt, oil/grease, etc. Remove the piston rod comp. and the piston rod B with care not to damage the sliding surface of the parts. With the power trim/tilt assembly removed from the outboard motor, connect the power tilt motor 2P connector and operate the power tilt motor until the piston rod comp. and the piston rod B reach the fully extended position. [1] OIL TANK CAP 1) Remove the oil tank cap. Drain the Automatic Transmission Fluid (ATF) from the oil tank.
Do not drain the Automatic Transmission Fluid (ATF) by pushing the piston rod comp. in. 2) Loosely tighten the oil tank cap on the oil tank. [2] OIL TANK Remove the three hex. bolts and remove the oil tank from the cylinder comp. Drain the Automatic Transmission Fluid (ATF) from the oil tank. [1] O-RING 3) Remove the O-ring from the cylinder comp. Replace the O-ring with a new one on assembly. [3] HEX. BOLT (3) 15-36