4) Remove the four hex. bolts and remove the power tilt motor assembly from the pump assembly. [1] HEX. BOLT (4) Drain the Automatic Transmission Fluid (ATF) from the pump assembly. [2] POWER TILT MOTOR ASSEMBLY [3] PUMP ASSEMBLY 5) Remove the O-ring from the power tilt motor assembly. Replace the O-ring with a new one on assembly. [1] O-RING [2] POWER TILT MOTOR ASSEMBLY 6) Remove the drive joint and the filter B from the pump assembly. [1] DRIVE JOINT Check the mesh of the filter B for blockage and tear. If it is torn, replace the filter B with a new one. If it is clogged with dust and dirt, blow the mesh with air to remove the blockage. Take care not to damage the mesh.
[2] FILTER B Drain the residual Automatic Transmission Fluid (ATF) from the pump assembly. [3] PUMP ASSEMBLY 7) Remove the socket bolt A and Bs, and remove the pump assembly from the cylinder comp. [3] O-RING (5) Remove the five O-rings and orifice collar from the cylinder comp. [2] PUMP ASSEMBLY [1] SOCKET BOLT B (2) Replace the O-rings with the new ones on assembly. [5] SOCKET BOLT A [4] ORIFICE COLLAR 15-37