8) Remove the internal circlip and remove the manual valve from the pump assembly. [3] PUMP ASSEMBLY Check the manual valve and the O-ring for deterioration, wear and damage. Replace them if necessary. [1] INTERNAL CIRCLIP [2] MANUAL VALVE Replace the manual valve with a new one on assembly. 9) Set the cylinder comp. in a vice as shown. Do not tighten the vice excessively, as it can damage the cylinder comp. NOTICE [2] CYLINDER COMP. [1] VICE 10) Check that the left and right piston rods are in the fully extended position. [1] ROD GUIDE COMP. 11) Loosen the rod guide comp. fully using the special tool as shown. TOOL:
Pin wrench, 4 mm 07SPA-ZW10200 [2] PIN WRENCH, 4 mm 07SPA-ZW10200 12) Remove the rod guide comp. and the piston rod Bs from the trim cylinders slowly. Do not push the piston rod Bs into the trim cylinders. 13) Drain the Automatic Transmission Fluid (ATF) from the trim cylinders. [1] ROD GUIDE COMP. (2) Remove the rod guide comps from the piston rod B. [2] PISTON ROD B (2) 15-38