14) Remove the O-ring from the rod guide comp. [1] DUST SEAL Replace the O-ring with a new one on assembly. [2] OIL SEAL 15) Insert a sharp-end screwdriver into the gap between the dust seal and the rod guide comp. Raise the dust seal and remove it from the rod guide comp. [4] ROD GUIDE COMP. Remove the oil seal in the rod guide comp. in the same manner. Replace the dust seal and the oil seal with the new ones on assembly. [3] O-RING Take care not to damage inside the rod guide comp. during this operation. [3] O-RING [5] SHARP-END SCREWDRIVER [6] Raise the seal. OIL SEAL [4] ROD GUIDE COMP. 16) Remove the backup ring and the O-ring from the piston rod B.
[1] PISTON ROD B Replace the backup ring and the O-ring with the new ones as a set on assembly. 17) Check the piston rod B. If it is scored or scratched, or if the rod is bent, replace the piston rod B with a new one. [2] BACKUP RING [3] O-RING 18) Hold the cylinder comp. in a vice (P. 15-38). 19) Check that the piston rod comp. is in the fully extended position. 20) Using the special tool, loosen the cylinder cap fully as shown. [1] PIN WRENCH, 6 mm 07SPA-ZW10100 TOOL: Pin wrench, 6 mm 07SPA-ZW10100 [2] CYLINDER CAP 15-39 [1] DUST SEAL [2]