e. ASSEMBLY Do not reuse the O-rings. Do not use a shop towel or equivalent cloth, and do not wear the gloves during this operation. Do not reuse the drained Automatic Transmission Fluid (ATF). When the operation is made by holding the cylinder comp. in a vice, do not tighten the vice excessively. It can damage the cylinder comp. Add the Automatic Transmission Fluid (ATF) slowly. Assemble the power trim/tilt assembly with the piston rod comp. and the piston rod B fully extended. Do not push in the piston rod comp. and the piston rod B. Do not allow the dust, dirt and other foreign material enter the cylinder comp. and the pump assembly during assembly.
Clean the parts with the fresh Automatic Transmission Fluid (ATF) and blow each port with compressed air to remove dust and dirt. Check that the parts are clean before assembly. After assembly, coat the joints or mating sections of the parts and the sections where the paint came off with rust preventive paint of the same color. 1) Hold the cylinder comp. in a vice as shown. Do not tighten the vice excessively as it can damage the cylinder comp. NOTICE [2] CYLINDER COMP. 2) Pour approximately 30 cm 3 (1.0 fl oz.) of the Automatic Transmission Fluid (ATF) in the piston rod chamber of the cylinder comp. [1] VICE 3) Apply Automatic Transmission Fluid (ATF) to the new O- ring and the backup ring.
Install the O-ring and backup ring on the free piston. [1] FREE PISTON 4) Apply Automatic Transmission Fluid (ATF) to the circumference of the free piston and push it in the piston rod chamber slowly until it bottoms out. [2] BACKUP RING (ATF) Install the backup ring on the free piston with care not to break it. NOTICE [3] O-RING [4] CYLINDER COMP. 15-42 Recommended oil Genuine Honda Automatic Transmission Fluid (ATF) DEXRON® or equivalent.