5) After installing the free piston, pour the fresh Automatic Transmission Fluid (ATF) slowly up to the top of the piston rod chamber of the cylinder comp. 6) Apply Automatic Transmission Fluid (ATF) to the new O- ring and install it on the piston rod comp. [1] CYLINDER COMP. [2] PISTON ROD COMP. 7) Apply Automatic Transmission Fluid (ATF) to the new O- ring and install it on the cylinder cap. 8) With the piston rod comp. fully extended, install the piston rod comp. slowly in the piston rod chamber of the cylinder comp. [3] CYLINDER CAP Loosely tighten the cylinder cap. Do not install the piston rod comp. by pushing it in the piston rod chamber.
[4] O-RINGS (ATF) 9) Tighten the cylinder cap to the specified torque using the special tool as shown. TOOL: Pin wrench, 6 mm 07SPA-ZW10100 TORQUE: 162 N . m (16.5 kgf . m, 119 lbf . ft) [1] PIN WRENCH, 6 mm 07SPA-ZW10100 [2] CYLINDER CAP 10) Pour the fresh Automatic Transmission Fluid (ATF) in the right and left trim cylinder chambers up to the top of the trim cylinder chamber. 15-43 [1] Pour slowly up to the top of the piston rod chamber. [1] Pou top cha r slowly up to the of the trim cylinder mber.