11) Apply Automatic Transmission Fluid (ATF) to the new O- ring and the backup ring and install them on the piston rod comp. [1] PISTON ROD B Install the backup ring on the free piston with care not to break it. [2] BACKUP RING (ATF) [3] O-RING 12) Apply Automatic Transmission Fluid (ATF) to the new oil seal. [1] DUST SEAL Holding the oil seal in the shape of “U” with your fingers, install it in the lower groove in the rod guide comp. [2] OIL SEAL 13) Apply Automatic Transmission Fluid (ATF) to the new dust seal. [3] ROD GUIDE COMP. (ATF) Holding the dust seal in the shape of “U” with your fingers, install it in the upper groove in the rod guide comp.
14) Apply Automatic Transmission Fluid (ATF) to the new O- ring and install it on the rod guide comp. [4] O-RING [3] ROD GUIDE COMP. [2] OIL SEAL [4] O-RING [1] DUST SEAL 15) Install the rod guide comp. on the piston rod B. Extend the piston rod fully and hold it in the position. 16) Holding the piston rod Bs aslant a little, set each of piston rod Bs in the left and right trim cylinder chambers. Do not install the piston rod Bs by pushing them into respective trim cylinders. [1] ROD GUIDE COMP. (2) 17) Install the piston rod B in the trim cylinder chamber slowly. [2] PISTON ROD B (2) 15-44