18) Holding the piston rod B in place, loosely tighten the rod guide comp. on the cylinder comp. [1] ROD GUIDE COMP. Do not install the piston rod Bs by pushing them into respective trim cylinders. 19) Using the special tool, tighten the left and right rod guide comps. to the specified torque as shown. TOOL: Pin wrench, 4 mm 07SPA-ZW10200 [2] PIN WRENCH, 4 mm 07SPA-ZW10200 TORQUE: 78 N . m (8.0 kgf . m, 58 lbf . ft) 20) Check the manual valve and the O-ring for deterioration, wear and damage. Replace the manual valve with a new one if necessary. [1] PUMP ASSEMBLY 21) Apply Automatic Transmission Fluid (ATF) to the manual valve O-ring.
[2]MANUAL VALVE Set the manual valve on the pump assembly and tighten it to the specified torque. TORQUE: 3.5 N . m (0.35 kgf . m, 2.5 lbf . ft) 22) Install the internal circlip securely in the groove in the pump assembly. [3]INTERNAL CIRCLIP (ATF) 23) Apply Automatic Transmission Fluid (ATF) to the five new O-rings and the orifice collar. [2] PUMP ASSEMBLY Set the five O-rings and the orifice collar in the indicated position of the cylinder comp. [1] SOCKET BOLT B (2) (ATF) 24) Install the pump assembly on the cylinder comp. with the socket bolt A and B. Tighten the socket bolt A and B to the specified torque. TORQUE: 8.5 N . m (0.85 kgf . m, 6.1 lbf .
ft) [3] O-RING (5) [5] SOCKET BOLT A [4] ORIFICE COLLAR 25) Fill the pump assembly with the fresh Automatic Transmission Fluid (ATF). [1] PUMP ASSEMBLY Do not fill up the pump assembly quickly. Pour the Automatic Transmission Fluid (ATF) in the pump assembly slowly. 15-45