honda — Power Trim/Tilt Assembly

26) Check the filter B for blockage and damage. Replace the filter B if it is damaged. [1] DRIVE JOINT Blow air through the filter B if it is clogged. Clean the filter B carefully to avoid damage. [2] FILTER B Install the filter B and the drive joint on the pump assembly. [3] PUMP ASSEMBLY 27) After installation, check the filter B for bubbles. Remove the bubbles with the oil bottle or equivalent tool if necessary. [1] OIL BOTTLE Be sure to remove the air bubbles, or it will cause air in the system. 28) After removing the air bubbles, fill the pump assembly fully with the Automatic Transmission Fluid (ATF) again.

29) Apply Automatic Transmission Fluid (ATF) to the new O- ring and install it on the power tilt motor assembly. [1] O-RING (ATF) [2] POWER TILT MOTOR ASSEMBLY 30) Install the power tilt motor assembly on the pump assembly aligning the projection on the power tilt motor assembly with the recess in the drive joint and with the motor wire of the power tilt motor assembly at the manual valve side. [1] MOTOR WIRE [2] RECESS IN DRIVE JOINT [3] PROJECTION 15-46