honda — Power Trim/Tilt Assembly

31) Set the four hex. bolts on the power tilt motor assembly and tighten the bolts to the specified torque. [1] HEX. BOLT (4) TORQUE: 5 N . m (0.5 kgf . m, 3.6 lbf . ft) [2] POWER TILT MOTOR ASSEMBLY [3] PUMP ASSEMBLY 32) Apply Automatic Transmission Fluid (ATF) to the new O- ring and install it on the cylinder comp. 33) Install the oil tank on the cylinder comp. and tighten the three hex. bolts to the specified torque. [1] OIL TANK (ATF) TORQUE: 5 N . m (0.5 kgf . m, 3.6 lbf . ft) [2] HEX. BOLT (3) [3] O-RING Do not overfill with Automatic Transmission Fluid (ATF).

Pouring the Automatic Transmission Fluid (ATF) while it is flowing out of the filler port will overfill the tank, and that will damage the oil seal of the motor when each rod is compressed. NOTICE [1] OIL TANK CAP 35) After filling the oil tank with Automatic Transmission Fluid (ATF), bleed air from the power trim/tilt assembly mounting on the outboard motor> (P. 15-48). 36) Tighten the oil tank cap to the specified torque. TORQUE: 2.5 N . m (0.25 kgf . m, 1.8 lbf . ft) [2] UPPER LIMIT 15-47 34) Remove the oil tank cap. Pour fresh Automatic Transmission Fluid (ATF) to the upper limit of the oil tank filler port. Oil capacity 0.68R (0.72 US qt, 0.60 Imp qt)