honda — Power Trim/Tilt Assembly

1) With the rods extended fully, push the “UP” side of the power tilt switch until the unit blows again. Push the “DN” side of the power tilt switch, and be sure that the rods compress. If the rods compress fully, go to the blow pressure inspection (P. 15-50). 2) If the rods do not compress after the step 1 operation, push the “DN” side of the power tilt switch while pushing the piston rod B, and check whether the rods compress. [1] POWER TILT SWITCH If the rods compress fully, go to the blow pressure inspection (P. 15-50). 3) If the rods still do not compress after the step 2 operation, loosen the manual valve and compress each rod. Tighten the manual valve securely again.

Push the “UP” side of the power tilt switch to extend the rods fully, then push the “DN” side of the switch and check whether the rods compress fully. If the rods compress fully, go to the blow pressure inspection (P. 15-50). 4) If the rods do not compress fully after the above operation, disassemble (P. 15-36) and reassemble (P. 15-42) the power trim/tilt assembly and bleed air with the power trim/tilt assembly not mounted on the outboard motor (P. 15-48). mounted on the outboard motor> Perform the following procedure after bleeding air without mounting the power trim/tilt assembly on the outboard motor (P. 15-48) and after blow pressure inspection (P. 15-50).

[3] MANUAL VALVE 1) Install the power trim/tilt assembly on the outboard motor securely (P. 15-30). 2) Push the “UP” side of the power tilt switch and raise the outboard motor to the uppermost position. Remove the oil tank cap, and check whether the Automatic Transmission Fluid (ATF) is at the upper limit of the oil filler port of the oil tank. If the Automatic Transmission Fluid (ATF) does not flow out of the oil filler port, add the Automatic Transmission Fluid (ATF) up to the upper limit of the oil filler port using a syringe or equivalent tool. 15-49 2] PISTON ROD S B [1] OIL TANK CAP [2] UPPER LIMIT [1] OIL TANK CAP