honda — Power Trim/Tilt Assembly

3) Lower the outboard motor slowly to the lowermost position by loosening the manual valve. [1] MANUAL VALVE 4) Tighten the manual valve securely. 5) Hold the outboard motor in the lowermost position for five minutes. 6) Then, push the “UP” side of the power tilt switch and raise the outboard motor to the uppermost position. Hold the outboard motor in this position for five minutes. After five minutes, check the fluid level in the oil tank (P. 15-47). [3] TO LOOSEN [2] TO TIGHTEN 7) Repeat the procedure from step 3 through 6 five times. 6.

BLOW PRESSURE INSPECTION After bleeding air from the power trim/tilt assembly without mounting on the outboard motor and checking each rod for proper compression, perform the following operation in the same manner as bleeding air without mounting on the outboard motor. [1] INTERNAL CIRCLIP 1) Operate each rod of the power trim/tilt assembly (i.e. move them up and down) several times and set the rods in the full extended position. [2] MANUAL VALVE 2) Check that the Automatic Transmission Fluid (ATF) is at the upper level in the oil tank (P. 15-47). 3) Using the special tools, check the blow pressure at the upper and lower chambers of the cylinder.

[1] OIL PRESSURE GAUGE JOINT B (Lower chamber) 07SPJ-ZW10200 a. LOWER CHAMBER BLOW PRESSURE 1) Remove the internal circlip and manual valve from the power trim/tilt assembly. Note that Automatic Transmission Fluid (ATF) will spurt out when the manual valve is removed without the rods fully extended. Move each rod to the fully extended position before removing the manual valve. [2] OIL PRESSURE GAUGE JOINT A (Upper chamber) 07SPJ-ZW10100 A small amount of the Automatic Transmission Fluid (ATF) will flow out when the manual valve is removed. Attach the special tools quickly.

2) Attach the special tool (oil pressure gauge joint B) for measurement of lower chamber blow pressure to the manual valve installation section as shown. Tighten the special tool to the specified torque. TOOL: Oil pressure gauge joint B 07SPJ-ZW10200 TORQUE: 9 N . m (0.9 kgf . m, 6.5 lbf . ft) 3) Attach a commercially available pressure gauge [P/T 1/4] which measures 14,710 kPa (150 kgf/cm 2 , 2,133 psi) or above to the special tool (oil pressure gauge joint B). 15-50 [3] PRESSURE GAUGE (Commercially available) [2] OIL PRESSURE GAUGE [2] OIL PRESSURE GAUGE JOINT B (Lower chamber) 07SPJ-ZW10200