honda — Power Trim/Tilt Assembly

4) Remove the oil tank cap. Check that Automatic Transmission Fluid (ATF) is at the upper limit of the filler port (P. 15-47). 5) Push the “DN” side of the power tilt switch to compress each rod fully. 6) Push the “UP” side of the power tilt switch to extend each rod fully again. Read the pressure gauge to measure the lower chamber blow pressure. 7) If the blow pressure is lower than the specified pressure, check each part of the power trim/tilt assembly for oil leakage (P. 15-54). 8) If there is no oil leakage but the pressure dropped sharp below the specification, check the power tilt motor assembly for the damaged oil seal. Disassemble the power tilt motor assembly (P.

15-53) and inspect (P. 15-55), and measure the lower chamber blow pressure again (P. 15-50). [1] POWER TILT SWITCH 9) Measure the upper chamber blow pressure. b. UPPER CHAMBER BLOW PRESSURE 1) After measuring the lower chamber blow pressure, remove the special tool (oil pressure gauge joint B) and the pressure gauge from the pump assembly with each rod full extended. Note that Automatic Transmission Fluid (ATF) will spurt out when the special tool is removed without the rods fully extended. Move each rod to the fully extended position before removing the special tool.

[1] PRESSURE GAUGE (Commercially available) A small amount of the Automatic Transmission Fluid (ATF) will flow out when the special tool (oil pressure gauge joint B) is removed. Attach the special tool (oil pressure gauge joint A) quickly. 2) Attach the special tool (oil pressure gauge joint A) for measurement of upper chamber blow pressure to the manual valve installation section as shown. Tighten the special tool to the specified torque. TOOL: Oil pressure gauge joint A 07SPJ-ZW10100 [2] OIL PRESSURE GAUGE JOINT A (Upper chamber) 07SPJ-ZW10100 TORQUE: 9 N . m (0.9 kgf . m, 6.5 lbf .

ft) 3) Attach a commercially available pressure gauge [P/T 1/4] which measures 14,710 kPa (150 kgf/cm 2 , 2,133 psi) or above to the special tool (oil pressure gauge joint B). 15-51 Lower chamber blow pressure 8,826 – 11,768 kPa (90 – 120 kgf/cm2, 1,280 – 1,707 psi)