honda — Power Trim/Tilt Assembly

4) Remove the oil tank cap. Check that Automatic Transmission Fluid (ATF) is at the upper limit of the filler port (P. 15-47). 5) Push the “DN” side of the power tilt switch to compress each rod fully. Read the pressure gauge to measure the upper chamber blow pressure. 6) If the blow pressure is lower than the specified pressure, check each part of the power trim/tilt assembly for oil leakage. 7) If there is no oil leakage but the pressure dropped sharp below the specification, check the power tilt motor assembly for the damaged oil seal. Disassemble the power tilt motor assembly (P. 15-53) and inspect (P. 15-55), and measure the upper chamber blow pressure again (P. 15-50).

[1] POWER TILT SWITCH 8) After checking, push the “UP” side of the power tilt switch and move each rod to the fully extended position. 9) Remove the special tool (oil pressure gauge joint A) and the pressure gauge. [1] INTERNAL CIRCLIP 10) Tighten the manual valve to the specified torque. TORQUE: 3.5 N . m (0.35 kgf . m, 2.5 lbf . ft) 11) With each rod in the fully extended position, remove the oil tank cap and check that the Automatic Transmission Fluid (ATF) is at the upper limit of the oil filler port (P. 15-47).

[2] MANUAL VALVE If the Automatic Transmission Fluid (ATF) does not flow out of the oil filler port, add the Automatic Transmission Fluid (ATF) up to the upper limit of the oil tank using a syringe or equivalent tool (P. 15-47). 15-52 Upper chamber blow pressure 3,923 – 7.355 kPa (40 – 75 kgf/cm2, 569 – 1,067 psi)