honda — Power Trim/Tilt Assembly

c. INSPECTION • BRUSH LENGTH Measure the brush length. If the brush length is less than the service limit, replace the front bracket assembly. • BREAKER ASSEMBLY [2] ARMATURE 1) Install the armature on the front bracket assembly. [1] BRACKET HOLDER 2) Connect the motor 2P connector to the outboard motor. 3) Operate the power tilt switch and check the breaker assembly for operation sound. The breaker is normal if there is operation sound from the breaker assembly. Replace the front bracket assembly if there is no operation sound from the breaker assembly.

[3] BREAKER ASSEMBLY • MICA DEPTH If the grooves are clogged or mica depth is less than the service limit, recut the groove using a hacksaw blade or a small file. If the mica depth is still less than the service limit, replace the armature. 0.5 mm (0.020 in) • ARMATURE Use the armature tester if it is available. CONTINUITY CHECK – SEGMENTS Check for continuity between the segments. If an open circuit exists between any two segments, replace the armature. 15-55 STANDARD SERVICE LIMIT 9.8 mm (0.39 in) 4.8 mm (0.19 in) SERVICE LIMIT 0.5 mm (0.020 in)