honda — Power Trim/Tilt Assembly

d. ASSEMBLY When the front bracket assembly is replaced with the new one, remove the 4 x 10 mm screw that secures the brush holder B. [1] FRONT BRACKET ASSEMBLY [3] BRUSH ASSEMBLY [2] BRUSH SPRINGS 1) Install the new O-ring and the oil seal on the front bracket assembly (P. 15-54). [4] PROJECTION Apply heat resisting grease to the oil seal lip. 2) Connect the motor wire (blue wire) terminal to the breaker assembly terminal. [10] BREAKER ASSEMBLY 3) Check the magnet in the yoke assembly for washer and other foreign material. There must be no washer, etc. on the magnet. Set the brush assembly terminal above the motor wire (green wire) terminal and loosely tighten the 4 x 10 mm screw.

Be sure that the motor wire (green wire) terminal and the brush assembly wire terminal contact the respective projections on the brush holder A, then tighten the 4 x 10 mm screw securely. [9] BLUE WIRE [5] BRUSH HOLDER A [8] TERMINAL [6] 4 x 16 mm SCREW [4] PROJECTION [7] GREEN WIRE 4) Check that the commutator surface is not contaminated with oil and grease. Set the two brush springs on the front bracket assembly and install the armature on the front bracket with the brush terminal pushed in the holder. [3] YOKE ASSEMBLY 5) Wrap the armature shaft with a shop towel or equivalent material and hold the shaft with the pliers.

[2] ARMATURE 6) Pulling the two motor wires of the yoke assembly side slowly, install the armature/front bracket assembly on the yoke assembly. [1] SHOP TOWEL If it is hard to install the armature/front bracket assembly on the yoke assembly, check whether the metal of yoke assembly (i.e. where the armature shaft is installed) is out of position and repeat the procedure from step 4. [4] MOTOR WIRES 7) Check that the armature turns smoothly and tighten the two 4 x 16 mm screws. After tightening the two 4 x 16 mm screws, connect the power tilt motor 2P connector and check whether the motor turns.

[6] PLIERS [5] FRONT BRACKET ASSEMBLY If the motor does not turn, disassemble the power tilt motor assembly again, and check whether the motor wire (blue wire) terminal is disconnected. 15-57