6) Install the lock nut and the shift pivot on each of the remote control cables. Align the groove in each of the remote control cables (shift and throttle sides) with the cutouts in the remote control cable plate, and install the remote control cables on the remote control cable plate. Fasten the undercase grommet band securely (P. 4-8). [1] SHIFT PIVOT (2) [2] GROOVES [3] REMOTE CONTROL CABLE (Throttle side) [4] REMOTE CONTROL CABLE (Shift side) [7] REMOTE CONTROL CABLE PLATE [5] CUTOUTS [6] REMOTE CONTROL CABLE GROMMET d. REMOTE CONTROL CABLE (SHIFT SIDE) INSTALLATION [1] FLAT PART OF DETENT ARM [2] Align.
Check the following before installing the remote control cables on the outboard motor. – Remote control cables are securely connected to the remote control box (P. 16-2). – Shift arm is in the “N” (Neutral) position. – Center of the neutral switch end is in line with the center of the flat part of the detent arm, and the detent arm roller is in the groove of the shift arm. If the detent arm roller is in the groove of the shift arm but the center of the neutral switch end is not in line with the center of the flat part of the detent arm, check the detent arm. Replace the detent arm with a new one if it is deformed or damaged.
[3] NEUTRAL SWITCH END [1] INNER CABLE [3] “N” (NEUTRAL) 1) Install the shift pivot on the remove control cable (shift side). Apply marine grease to the mounting part of the shift link pin on the shift pivot and to the shift link pin. [2] CABLE OUTER SEAL 2) Check that the remote control cable (shift side) is detached from the shift link pin. Move the remote control lever fully to “F” (Forward) position, then return it slowly to the “N” (Neutral) position. [4] “F” (FORWARD) [6] MARK (A) [5] REMOTE CONTROL BOX 3) With the remote control lever in the position described in step 2, mark (A) at the end of the cable outer seal of the inner cable. [7] (MARINE GREASE) 17-7