4) Install the remote control cable plate on the flat surface of the remote control cable grommet by aligning the projection on the remote control cable plate with the groove in the under cover front bracket. Take care not to move 5) Connect the indicator light 6P connector and the remote control cable 14P connector. Install the indicator light 6P connector and the remote control cable 14P connector on the neutral switch bracket. [2] REMOTE CONTROL CABLE 14P CONNECTOR [1] INDICATOR LIGHT 6P CONNECTOR [3] NEUTRAL SWITCH BRACKET 17-6 le plate with he cable bracket A. [1] 6 x 16 mm HEX.
BOLT [10] 6 mm WASHER [9] FLAT SURFACE [8] STARTER CABLE [7] CABLE BRACKET A [2] REMOTE CABLE P CONTROL LATE TION CONTROL ROMMET E IN UNDER FRONT BRACKET COVER FRONT T [3] PROJEC TION [5] GROOV COVER E IN UNDER FRONT BRACKET [6] UNDER BRACKE COVER FRON T