honda — Shift Arm/Neutral Switch

9) With the remote control cable (shift side) in the position described in step 7 (i.e. the mark (C) aligns with the cable outer seal end), adjust the shift side remote control cable length by turning the shift pivot so that the shift pivot sets on the shift link pin smoothly. [1] REMOTE CONTROL CABLE (Shift side) Take care not to move the mark (C) out of alignment. Set the shift pivot on the shift link pin with care not to move the shift link pin from the center of the free play. NOTICE [2] SHIFT PIVOT [2] SHIFT PIVOT [3] SHIFT LINK PIN [1] REMOTE CONTROL CABLE (Shift side) 10) After connecting the cable, move the remote control lever back and forth and check for shift.

When it is hard to put the remote control lever in the “F” (Forward) or “R” (Reverse) position with the engine stopped, shift the gear while turning the propeller or propeller shaft. Do not shift the gear with force, or damage to the shift system can result. NOTICE [1] ADJUSTMENT RANGE 11) If the gear is not in neutral by moving the remote control lever from the “F” (Forward) to the “N” (Neutral) position, remove the shift side remote control cable from the shift link pin and move the inner cable toward the mark (A). Repeat the procedure from the step 8 (P. 17-8).

[2] MARK (A) [3] MARK (C) 12) If the gear is not in neutral by moving the remote control lever from the “R” (Reverse) to the “N” (Neutral) position, remove the shift side remote control cable from the shift link pin and move the inner cable toward the mark (B). Repeat the procedure from the step 8 (P. 17-8). [1] ADJUSTMENT RANGE 13) After adjustment, set the remote control lever in each position and check for operation. If the gear is not in neutral securely, perform the step 11 or 12 again. [2] MARK (C) [3] MARK (B) 14) Adjust the shift side remote control cable after connection (P. 3-24). Tighten the shift pivot lock nut securely. 17-9