honda — Shift Arm/Neutral Switch

2. SHIFT LINK BRACKET/NEUTRAL SWITCH a. REMOVAL Remove the following parts. – Engine cover (P. 4-2) – Front separate cover (P. 4-7) – L./R. engine under cover (P. 4-9) – Remote control cable/grommet (P. 17-2) 1) Remove the throttle rod linkage pivot from the throttle plate. 2) Remove the two 6 x 18 mm flange bolts from the shift link bracket assembly. Remove the link pin of the shift link bracket assembly from the shift arm, and remove the shift link bracket assembly. [1] THROTTLE PLATE [2] THROTTLE ROD 6 x 18 (2) [3] SHIFT LINK BRACKET ASSEMBLY [4] LINK PIN [5] SHIFT ARM 3) Move the shift arm to the “N” (Neutral) position.

Remove the 12 mm snap ring and the 12 mm washer from the shift shaft B. [1] 12 mm SNAP RING [2] 12 mm WASHER [3] SHIFT ARM [Move to “N” (Neutral) position.] 17-11