honda — Shift Arm/Neutral Switch

d. SHIFT SHAFT B CORRECTION [1] STOPPER [1] STOPPER Correct the shift shaft B with the seal holder removed. Correct the shift shaft B only when the shift shaft B is raised or when it is disengaged from the shift shaft A in the mounting case. Remove the following pars before correction. – Gear case assembly (P. 14-3, 42) [3] SHIFT SHAFT A [2] SHIFT SHAFT B (Raise the shift shaft B and turn it clockwise.) 1) Turn the shift shaft B clockwise until the shift shaft A comes in contact with the stopper in the mounting case as shown.

[4] SHIFT SHAFT B (If the shift shaft B comes in contact with the stopper before the shift shaft A does, raise the shift shaft B and turn it counterclockwise.) If the shift shaft B comes in contact with the stopper before the shift shaft A does, raise the shift shaft B and turn it counterclockwise until it engages with the shift shaft A. Then turn the shift shaft B clockwise until the shift shaft A comes in contact with the stopper. NOTICE [3] SHIFT SHAFT A 2) Raise the shift shaft B slowly while holding the shift shaft A in contact with the stopper in the mounting case.

[1] STOPPER 3) With the raised shift shaft B pushed against the stopper in the mounting case, lower the shift shaft B slowly and engage it with the shift shaft A. NOTICE Hold the shift shaft A not to move when engaging it with the shift shaft B. [3] SHIFT SHAFT A [2] SHIFT SHAFT B (Turn clockwise.) 4) After correction, check for proper shifting of the gear. 5) Install the seal holder (P. 17-23) and the gear case assembly (P. 14-5, 44). [4] SHIFT SHAFT B (Lower slowly and engage with the shift shaft A) [3] SHIFT SHAFT A 17-22