e. ASSEMBLY [1] 12 x 26 x 7 mm OIL SEAL 1) Apply marine grease to a new 25 x 2.4 mm O-ring. Apply soapy water to the outer surface of the 12 x 26 x 7 mm oil seal. [2] (Apply soapy water to the outer surface.) Apply marine grease to the mounting part of the O-ring on the seal holder. [3] SEAL HOLDER 2) Install the 12 x 26 x 7 mm oil seal and 25 x 2.4 mm O-ring on the seal holder. [5] (MARINE GREASE) [4] 25 x 2.4 mm O-RING f. INSTALLATION 1) Tighten the cable bracket A with the 6 x 14 mm flange bolt securely. 6 x 20 (2) 2) Protect the shift shaft B by taping around the stepped part of the shift shaft B.
[1] (Apply marine grease to the lip.) 3) Apply marine grease to the 12 x 26 x 7 mm oil seal lip mounted on the seal holder. [5] SEAL HOLDER [2] Tape around the stepped part. 4) Install the seal holder over the shift shaft B slowly and tighten the seal holder with the two 6 x 20 mm flange bolts securely. NOTICE Install the seal holder with care not to raise the shift shaft B. Correct the shift shaft B if it is raised or if it is disengaged from the shift shaft A in the mounting case (P. 17-22). [4] CABLE BRACKET A Note that assembly with the shift shaft A and B out of alignment will prevent proper shifting. [3] SHIFT SHAFT B 6 x 14 5) Remove the tape from the shift shaft B.
NOTICE [1] STARTER CABLE [2] ALTERNATOR FUSE CABLE Check that the oil seal lip is not turned up during removal of the tape. 6) Set the starter cable and the alternator fuse cable in the cable bracket A as shown. 7) Install the following parts. – Shift link bracket/neutral switch (P. 17-17) – Remote control cable/grommet (P. 17-5) – R. engine under covers (P. 4-15) – Front separate cover (P. 4-7) – Engine cover (P. 4-2) [3] CABLE BRACKET A 17-23