b. DISASSEMBLY 1) Move the terminal cover aside. Remove the 8 mm washer- nut and disconnect the motor wire from the S terminal. [1] 8 mm WASHER-NUT [2] MOTOR WIRE [3] S TERMINAL [4] STARTER MAGNETIC SWITCH 2) Remove the 6 x 22 mm washer screws and the O-rings. Remove the magnetic switch, spring and the plunger. [1] STARTER MAGNETIC SWITCH [2] SPRING [3] PLUNGER [5] 6 x 22 mm SCREW (2) [4] O-RING (2) Do not reuse. 3) Remove the two through bolts and remove the yoke/rear bracket assembly. [5] YOKE/REAR BRACKET ASSEMBLY [1] THROUGH BOLT (2) 4) Remove the gasket and plate. [2] GASKET [4] FRONT BRACKET ASSEMBLY [3] PLATE 18-2