honda — Electrical Equipment

2. STARTER CABLE a. REMOVAL Remove the following parts. – Engine cover (P. 4-2) – Front separate cover (P. 4-7) [1] STARTER CABLE 1P CONNECTOR (W WIRE) Disconnect the starter cable from the battery before disconnecting and connecting the starter cable. NOTICE 1) Release the starter cable from the two harness clips. 2) Release the starter cable 1P connector (White wire) from the connector bracket C. [2] CONNECTOR BRACKET C [3] STARTER CABLE [4] HARNESS CLIP (2) 3) Disconnect the starter cable 1P connector (White wire). 4) Remove and disconnect the two 8 mm washer-nuts, alternator fuse cable, 8 mm washer and the positive (+) starter cable from the magnetic switch B terminal.

[1] 8 mm WASHER- NUT (2) [2] ALTERNATOR FUSE CABLE [3] 8 mm WASHER [4] STARTER CABLE (+) [5] B TERMINAL 5) Remove the 8 x 18 mm flange bolt from the crankcase, then disconnect the negative (–) starter cable. [1] CABLE BRACKET B [2] STARTER CABLE (–) 6) Remove the harness band clip that secures the starter cable from the cable bracket B. Remove the wire harness clip. 8 x 18 [3] WIRE HARNESS CLIP [4] HARNESS BAND CLIP 18-15