honda — Electrical Equipment

c. INSTALLATION 1) Secure the alternator fuse cable and the starter cable with the cable bracket A as shown. [1] CABLE BRACKET A [2] STARTER CABLE [2] STARTER CABLE [3] ALTERNATOR FUSE CABLE [1] CABLE BRACKET A 2) Tighten the 8 x 18 mm flange bolt to the specified torque while pushing the negative (–) starter cable against the projection on the crankcase. [1] CABLE BRACKET B [2] STARTER CABLE (–) TORQUE: 26 N . m (2.7 kgf . m, 20 lbf . ft) 3) Install the harness band clip, that clamps the starter cable, on the cable bracket B. 4) Clamp the alternator fuse cable and the starter cable with the wire harness clamp. Check that the cables are not interfering with the shift arm.

NOTICE 8 x 18 [3] WIRE HARNESS CLIP [4] HARNESS BAND CLIP [5] PROJECTION [6] STARTER CABLE (–) TERMINAL 18-17