5) Install the positive (+) starter cable on the magnetic switch B terminal at right angles to the vertical center line of the magnetic switch as shown. Tighten the 8 mm washer-nut to the specified torque. [1] 8 mm WASHER- NUT [2] TERMINAL COVER [6] ALTERNATOR FUSE CABLE TORQUE: 11 N . m (1.1 kgf . m, 8 lbf . ft) After tightening, set the 8 mm washer on the magnetic switch B terminal. [5] 8 mm WASHER [1] 8 mm WASHER- NUT 6) Install the alternator fuse cable on the magnetic switch B terminal at right angles to the vertical center line of the magnetic switch as shown. Tighten the 8 mm washer-nut to the specified torque. [4] STARTER CABLE (+) TORQUE: 11 N . m (1.1 kgf . m, 8 lbf .
ft) [3] B TERMINAL After tightening, set the terminal cover on the magnetic switch B terminal. [6] ALTERNATOR FUSE CABLE [4] STARTER CABLE (+) 7) Connect the starter cable 1P connector (White wire). 8) Set the starter cable 1P connector (White wire) on the connector bracket C. 9) Secure the starter cable with the two harness clips. [1] STARTER CABLE 1P CONNECTOR (W WIRE) 10) Install the following parts. – Front separate cover (P. 4-7) – Engine cover (P. 4-2) [2] CONNECTOR BRACKET C [3] STARTER CABLE [4] HARNESS CLIP (2) 18-18