4. POWER TILT RELAY/CONNECTOR BRACKET A a. REMOVAL/INSTALLATION Remove the following parts. – Engine cover (P 4-2) – L./R. engine under covers (P. 4-9) – Under cover front bracket (P. 4-20) Remove each connector from the connector bracket A, then remove the connector bracket A and the power tilt relay. On installation, position the connectors and harnesses in the proper position (P. 2-53 through P. 2-56). [2] HARNESS BAND CLIP (3) [3] TP SENSOR 3P CONNECTOR [4] HARNESS CLIP [1] MAIN WIRE HARNESS INSTALLATION: Clamp the taped part of the water level sensor wire and clamp the main wire harness. [5] WATER LEVEL SENSOR 2P CONNECTOR INSTALLATION: P. 3-21 INSPECTION: P.
3-19,20 [6] POWER TILT RELAY 3P CONNECTOR [12] NEUTRAL SWITCH 2P CONNECTOR [7] TRIM ANGLE SENSOR 2P CONNECTOR [8] POWER TILT MOTOR 2P CONNECTOR [11] ALTERNATOR FUSE CABLE [10] FUEL TUBE A [9] POWER TILT RELAY 1P CONNECTOR INSPECTION: Check for deterioration and cracks. Replace if necessary. 18-27