honda — Operation

19. OPERATION 1. DOHC (SWING ARM TYPE) + VTEC 2. CHAIN DRIVE CAM DRIVE SYSTEM 3. INDEPENDENT CYLINDER HEAD/ CYLINDER BLOCK COOLING SYSTEM 4. AIR/FUEL RATIO O 2 FEEDBACK CONTROL BY A/F SENSOR 1. DOHC (SWING ARM TYPE) + VTEC STRUCTURE AND FEATURES VTEC (BF150A only) The VTEC adapted on the BF150A outboard motors features the two cam profiles (for low and high engine speeds) and the corresponding three rocker arms to drive the intake valve.

Receiving the signal from the ECM, the VTEC solenoid valve turns the hydraulic pressure ON and OFF, moving the rocker arm pistons built in the rocker arms and thereby combining and separating the three rocker arms to select either of the two modes and two valve timings that are suitable for the running conditions (e.g. engine speed, load, etc.). – When the engine speed is low [engine rpm is approx. 4,300 min (rpm) or below], the rocker arm piston is retracted in the rocker arm. Each rocker arm is separate from the other making the independent movement. The center rocker arm, designed for the high engine speed, turns idle and the right and left rocker arms trace to the low engine speed cams.

Therefore, the two intake side valves are driven in the low engine speed cam profile. Thus, improvement of the torque in full throttle low speed range was realized compared to the conventional fixed valve timing method. – When the engine speed is high [engine rpm is higher than approx. 4,300 min (rpm)], the VTEC solenoid valve functions according to the signal from the ECM, extruding the rocker arm pistons from the rocker arm and combining the three rocker arms. As the center rocker arm, which is designed for the high engine speed, traces to the high speed cam, the two intake side valves are driven in the high engine speed cam profile.

Thus, the two valves function in the valve timing that is specially designed for the high speed range, which assures improvement in engine horsepower. DOHC The DOHC engine is adopted on these models, which realized center plug layout designed to contribute to improved fuel consumption efficiency. Though the engine is the DOHC type, it also adopted the swing arm rocker arm, which allows valve clearance adjustment with the adjusting screw and eliminated shim engagement that is poor in operationability. EXHAUST CAMSHAFT INTAKE CAMSHAFT EXHAUST ROCKER ARM INTAKE ROCKER ARM (SWING ARM TYPE) Built in VTEC system VALVE ADJUSTING SCREW VALVE ADJUSTING SCREW CENTER PLUG ADOPTED 19-1