honda — Maintenance

2. ENGINE OIL [1] DIPSTICK Oil Level Inspection: [2] UPPER LIMIT Check the engine oil level with the engine stopped and the outboard motor in the vertical position. 1) Remove the engine cover. 2) Remove the dipstick and wipe it clean. [3] LOWER LIMIT 3) Insert the dipstick all the way in the oil level pipe, then pull it out and read the oil level. 4) If the oil level is low, remove the oil filler cap and add the recommended oil to reach the upper limit mark on the dipstick. 5) Reinstall the oil filler cap and dipstick. Oil Change: Drain the used oil while the engine is warm. Warm oil drains quickly and completely. [1] OIL FILLER CAP 1) Remove the oil filler cap and the drain plug cover.

2) Attach the drain plug cover to the oil drain guide of the oil case. 3) Place a suitable oil container next to the outboard motor, and remove the oil drain plug bolt. Please dispose of used motor oil in a manner that is compatible with the environment. We suggest you take used oil in a sealed container to your local recycling canter or service station for reclamation. Do not throw it in the trash, pour it on the ground, or down a drain. CAUTION [1] DRAIN PLUG COVER Used engine oil contains substances that have been identified as carcinogenic. If repeatedly left in contact with the skin for prolonged periods, it may cause skin cancer.

Wash your hands thoroughly with soap and water as soon as possible after contact with used engine oil. [2] OIL DRAIN PLUG BOLT [1] 12 mm DRAIN PLUG WASHER 4) Replace the 12 mm drain plug washer with a new one, and reinstall the oil drain plug bolt. Tighten the oil drain plug bolt to the specified torque. [3] DRAIN PLUG GUIDE TORQUE: 23 N . m (2.3 kgf . m, 17 lbf . ft) 5) Reinstall the drain plug cover. 3-2