honda — Maintenance

6) Refill with the recommended engine oil to the upper limit mark on the dipstick. [1] SAE Viscosity Grades [2] AMBIENT TEMPERATURE NOTICE Using nondetergent oil can shorten the engine’s service life and using 2-stroke oil can damage the engine. 7) Install the engine cover (P. 4-2). [1] OIL FILTER 3. OIL FILTER Replacement: 1) Drain the engine oil, then reinstall the oil drain plug bolt and drain plug cover, as described in the oil change procedure. [2] OIL FILTER WRENCH 07HAA-PJ70101 2) Place a shop towel under the oil filter to absorb any spilled oil, then remove the oil filter with an special tool. TOOL:

Oil filter wrench 07HAA-PJ70101 3) Drain the used oil filter into a suitable container for oil disposal (P. 3-2). 4) Clean the filter mounting base, and coat the seal of the new oil filter with clean engine oil. Use only a genuine Honda oil filter or a filter of equivalent quality specified for you model. Using the wrong Honda filter, or a not-Honda filter which is not of equivalent quality, may cause engine damage. 5) Screw on the new oil filter by hand, until the seal contacts the filter mounting base, then use an special tool to tighten the filter an additional 7/8 turn. [1] RUBBER SEAL TOOL: Oil filter wrench 07HAA-PJ70101 TORQUE: 12 N . m (1.2 kgf . m, 9 lbf .

ft) 6) Refill the engine with the specified amount of the recommended oil, as described in the oil change procedure. Reinstall the oil filter cap and dipstick. 7) Start the engine, and check the leaks. 8) Stop the engine, and check the oil level as described on page 3-2. If necessary, add oil to the upper limit mark on the dipstick. 9) Reinstall the engine cover. 3-3 Engine oil capacity Without oil filter replacement: 6.5R (6.9 US qt, 5.7 Imp qt) With oil filter replacement: 6.7R (7.1 US qt, 5.9 Imp qt) Recommended engine oil SAE 10W-30 API Service classification SG/SH/SJ