honda — Maintenance

4. GEAR CASE OIL Inspection: 1) Place the outboard motor on a level surface and position it vertically. 2) Remove the oil level bolt and check whether the gear case oil flows out of the gear case. If it flows out, be sure to catch the oil in a suitable container. Replace the O-ring on assembly. 3) If the oil does not flow out, add oil. 4) Coat a new O-ring with clean engine oil and install the O- ring on the oil level bolt. Set the oil level bolt on the gear case and tighten the bolt to the specified torque. [1] 5.5 x 1.5 mm O-RING TORQUE: 3.4 N . m (0.35 kgf . m, 2.5 lbf . ft) [2] OIL LEVEL BOLT Addition of gear oil:

[1] OIL LEVEL BOLT 1) Remove the oil drain bolt, and install the commercially available gear oil pump in the oil drain bolt hole. Replace the O-ring on assembly. 2) Remove the oil level bolt, and add the gear oil until it flows out of the oil level bolt hole. Replace the O-ring on assembly. [2] OIL DRAIN BOLT 3) Check for the metal particles on the magnet end of the oil drain bolt. [2] OIL DRAIN BOLT [3] MAGNET 4) If there are metal particles on the magnet end of the oil drain bolt, disassemble the gear case assembly and check (See section 14). 5) After adding the gear oil, apply clean engine oil to the new O-rings and install them on the oil drain bolt and the oil level bolt.

Set the oil drain bolt and the oil level bolt on the gear case, and tighten the bolts to the specified torque. [4] GEAR OIL PUMP (Commercially available) TORQUE: 3.4 N . m (0.35 kgf . m, 2.5 lbf . ft) 3-4 Gear oil capacity 0.98R (1.04 US qt, 0.86 Imp qt) Recommended gear oil MARINE SAE 90 Hypoid gear oil API Service classification (GL-4)