honda — Maintenance

Replacement: [1] OIL LEVEL BOLT 1) Place the outboard motor on a level surface and tilt up the outboard motor. 2) Remove the oil level bolt and the oil drain bolt, and drain the old oil. Replace the O-rings on assembly. If there is water in the oil, the water will flow out first when the oil drain bolt is removed, or the oil will be a milky color. If water in the gear oil is detected, check the gaskets and water seals for damage, and check the torque on the gear case bolts. 3) Check for the metal particles on the magnet end of the oil drain bolt (P. 3-4).

[2] OIL DRAIN BOLT 4) If there are metal particles on the magnet end of the oil drain bolt, disassemble the gear case assembly and check (See section 14). 5) Install a commercially available gear oil pump in the oil drain bolt hole, and add gear oil until it flows out of the oil level bolt hole. [1] 5.5 x 1.5 mm O-RING 6) After adding the gear oil, apply clean engine oil to the new O-rings and install them on the oil drain bolt and the oil level bolt. Set the oil drain bolt and the oil level bolt on the gear case, and tighten the bolts to the specified torque. [2] OIL DRAIN BOLT TORQUE: 3.4 N . m (0.35 kgf . m, 2.5 lbf .

ft) [1] GEAR OIL PUMP (Commercially available) 3-5 Gear oil capacity 0.98R (1.04 US qt, 0.86 Imp qt) Recommended gear oil MARINE SAE 90 Hypoid gear oil API Service classification (GL-4)