honda — Maintenance

5) Remove the 6 x 25 mm socket bolts and remove each ignition coil from the corresponding spark plug. [1] No.1 IGNITION COIL Pull out each ignition coil halfway. 6) Disconnect the ignition coil 3P connector from each ignition coil. [2] No.2 IGNITION COIL Remove each ignition coils. NOTICE Do not pull out the ignition coils excessively. [3] No.3 IGNITION COIL Do not drop the ignition coils and do not strike on the ignition coils, either, during removal/installation of the coils. Do not reuse the ignition coils when they are dropped. [4] No.4 IGNITION COIL 7) Clean any dirt from around the spark plug bases. [5] IGNITION COIL [6] 8) Remove the spark plugs using a spark plug wrench.

[1] SPARK PLUG WRENCH 3-7 [7] IGNITION 3P CONNECT 6 x 25 mm SOCKET BOLT (2) COIL OR