honda — Maintenance

[1] SEALING WASHER 1.0 – 1.1 mm (0.039 – 0.043 in) [3] Damaged washer [2] Cracked insulation [4] Worn or deformed electrodes 4) Replace the spark plugs with the new ones if the center electrode is rounded as shown. [5] Center electrode NOTICE These outboard motors are equipped with the iridium spark plugs. Do not adjust the spark plug gap. After cleaning the spark plugs with a plug cleaner, remove the sand thoroughly from the spark plugs. Never clean the spark plugs with a stiff wire brush. It can damage the fine-grain film of the iridium chips of the iridium spark plug. 5) Make sure each sealing washer is in good condition.

With each spark plug sealing washer attached, thread the spark plugs in by hand to seat the sealing washers and prevent crossthreading. Then tighten with a plug wrench (an additional 1/2 turn if a new plug) to compress the sealing washer. If you are reusing a plug, tighten 1/8 – 1/4 turn after the plug seats. [2] MUD GUARD CLIPS TORQUE: 18 N . m (1.8 kgf . m, 13 lbf . ft) [1] Lip on reverse side of grommet. NOTICE A loose spark plugs can become very hot and can damage the engine. Overtightening the spark plugs can damage the threads in the engine. 6) Install the ignition coils and tighten each with the 6 x 25 mm socket bolt securely (P. 3-7).

7) Connect the ignition coil 3P connector to each ignition coil and install the PHC cover (P. 3-6 and 7). 8) Push in the two mud guard clips at the top of the under cover grommet securely until they click. 9) Check that the lip at the reverse side of the under cover grommet is engaged with the L./R. engine under covers securely. Check that the under cover grommet adheres to the engine under covers securely. If the projections on the reverse side of the under cover grommet are out of position, set them on the under cover grommet properly. [3] Projections on reverse side of grommet. [4] UNDER COVER GROMMET 10) Install the engine cover (P. 4-2). 3-8 Inspection/Cleaning:

1) Visually inspect the spark plugs. Discard the plugs if the insulators are cracked or chipped. 2) Remove carbon or other deposits with a plug cleaner. NOTICE Do not spray the cleaner more than 20 seconds. 3) Measure the plug gap with a wire-type feeler gauge. If the measurement is out of the specification, replace the spark plug. Spark plug gap 1.0 – 1.1 mm (0.039 – 0.043 in) Service limit: 1.3 mm (0.051 in) Recommended spark plug IZFR6K11 (NGK) SKJ20DR-M11 (DENSO)