JCB — Speed Sensor

www.WorkshopManuals.co.uk Powershift Gearbox Speed Sensor Powershift machines fitted with an electronic control unit (ShiftMaster ECU) or a speedometer have a speed sensor D fitted. The speed sensor detects the speed of rotation of the gearbox output shaft and relays this information to the ECU or speedometer as applicable. The sensor detects the passing of the gear teeth on the output gear. When adjacent to the top of a gear tooth the sensor electrical output turns ON, when adjacent to a gap between the teeth the sensor output turns OFF. In this way the frequency of the electrical signal changes according to the speed of gear rotation and therefore machine road speed.

D The ShiftMaster ECU uses the input from the speed sensor to determine gear shift points. Failure of the speed sensor or its wiring will enable an ECU ‘Limp Mode’, preventing the use of 4th, 5th, and 6th gears. See Fault Finding - Powershift Gearbox . Testing The speed sensor can be tested in situ without removing it by means of service test harness 892/01096 . E 1 Park the machine on firm level ground, engage the parking brake and set the transmission to neutral. Lower the loader arms to the ground. Switch OFF the engine and remove the starter key. 2 Connect the test harness E as shown.

Tie back and secure the wires clear of the driveshaft and other moving components, in a position where the light emitting diode (LED) can be seen while operating the machine. 3 Turn the engine ON and drive the machine forward approximately 2 m (6 ft), make sure it is clear in front. Alternatively raise the wheels off the ground. If the sensor is operating correctly the LED will illuminate as the gear teeth pass the sensor, when the speed increases the LED will flash at a greater frequency until becoming continuously illuminated at higher speeds. A B C Key: A Ground B +V C Output 4 If the LED fails to illuminate carefully check the relevant wires and connectors for damage.

Repair as required and re-test the sensor as described above. It should be noted that the speed sensor is normally a reliable component and a fault is more likely attributed to damaged wires or electrical connectors, see Electrical Connections - Powershift Gearbox - 6 Speed . A405380 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1 Section F Transmission Section F 67 - 1 67 - 1 Service Procedures