www.WorkshopManuals.co.uk Powershift Gearbox - 6 Speed (ShiftMaster) 9803/3280 Purchased from www.WorkshopManuals.co.uk Issue 1 Section F Transmission Section F 68 - 1 68 - 1 Service Procedures Electronic Control Unit The PS766 6 speed gearbox is controlled by an Electronic Control Unit (ShiftMaster ECU). The ECU is located behind the front console as shown at A. The ECU is housed in a rugged case protected from ingress of dirt and moisture. Gearbox faults are more likely to be caused by faulty or damaged wiring, electrical components or hydraulic faults than by failure of the ShiftMaster ECU. Fault Finding When fault finding note the following:
Make sure you understand the normal operation characteristics of the 6 speed gearbox. Some characteristics may be interpreted as faults by some operators. See Basic Operation - ShiftMaster Operation Characteristics. The ShiftMaster ECU incorporates ‘Limp Modes’. These modes can operate in response to other gearbox faults. Make sure you understand the characteristics of the ‘Limp Modes’, see Fault Finding - Powershift Gearbox. The simplest and best way to fault find the 6 speed gearbox electrical system, (including the ECU) is by using ShiftMaster Diagnostics software and a laptop PC. See Diagnostics User Guide.
This diagnostics system enables the engineer to quickly identify faults with specific electrical circuits or devices. The devices electrical connections, locations and wire identifications are given in Electrical Connections - Powershift Gearbox - 6 Speed. See also Section C - Harness Data. If the facilities to use the ShiftMaster Diagnostics software system are not available, the gearbox and ECU can still be checked using a conventional multimeter, see Electrical Connections - Powershift Gearbox - 6 Speed. See also Section C - Harness Data. Software Upgrades From time to time a ShiftMaster ECU ‘Application Software’ upgrades may be made available by JCB Service.
If necessary ‘Application Software’ can be loaded into the ECU flash memory using a laptop PC and the ShiftMaster Flash Programmer application. This application is part of the JCB Service Master package found on the JCB Service Technical Information CD’s. The Flash Programmer application includes comprehensive help files. Note that the ECU contains 2 sets of software, ‘Application Software’ and ‘Setup Data’. The ‘Setup Data’ is specific to a machine variant and can not be changed or replaced. Renewing The ECU Before renewing the ECU note the following: The ShiftMaster ECU is a non serviceable part. Any units returned under warranty found to have been tampered with will invalidate any claim.
ECU’s are configured at the factory for each machine variant and are not interchangeable between machines. Although the part numbers may be the same, the internal software may not be. DO NOT interchange ECU’s between machines. Before renewing the ECU carry out all the relevant fault finding and diagnostics to confirm ECU failure. Units returned under warranty found not to be faulty will invalidate any claim. A A405370