24. SERVICE PROCEDURE 24.2.2 CLEAN INSIDE OF COOLING SYSTEM A WARNING e@ Soon after the engine has been stopped, the coolant is hot and can cause personal injury. Allow the engine to cool before draining water. Since cleaning is performed while the engine is running, it is very dangerous to enter the rear side of the machine as the machine may suddenly start moving. If the under cover is left removed, it may interfere with the fan. While the engine is running, never enter the rear side of the machine. Never remove the radiator cap when the engine is at operating temperature. At operating temperature, the coolant is under pressure.
Steam blowing up from the radiator could cause personal injury. Allow the engine to cool until the radiator filler cap is cool enough to touch with your hand. Remove the filler cap slowly to allow pressure to be relieved. e Clean the inside of the cooling system change the coolant and replace the corrosion resistor (option) according to the table below.
Kind of coolant Permanent type antifreeze {All season type) Non permanent type antifreeze containing e Cleaning inside of cooling system and changing coolant Replacing corrosion resistor (option) Every year (autumn) or every 2000 hours whichever comes first Every 6 months (spring, Every 1000 hours and autumn) ethylene glycol (Winter, {Drain antifreeze in spring, when cleaning the inside of the cooling one season type) add antifreeze in autumn) changing coolant When Every 6 months or every 1000 hours whichever comes first not using antifreeze system and when Stop the machine on level ground when cleaning or changing the coolant. Use a permanent type of antifreeze.
lf, for some reason, it is impossible to use permanent type antifreeze, use an antifreeze containing ethylene glycol. 3-28