Komatsu PC210-6K — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 4. If small holes or thinner parts are found on the element when it is checked with an electric bulb after cleaning replace the ele- ment. NOTICE Do not use an element whose damaged. When cleaning the element, do something. the cloth and tape folds not or hit gasket or it or beat seal are it against 5. Remove 6. Install the cleaned 7. Replace seal washer ® or wing nut @ with new parts if they are broken. 8. Remove evacuator valve © After cleaning, install it. element Replacing inner element 1. First remove the outer used for cover in Step 1. and fix it with the wing nut. and clean with compressed element, and then remove the air. inner element.

To prevent dust from getting in, use a clean cloth or tape to cover the air connector (outlet side). Clean the air cleaner installed in Step 2. body interior, then remove the cover Fit a new inner element to the connector and tighten it with nuts. Do not clean and reinstall a inner element. Install the outer element and fix it with the wing nut. 3-27