Komatsu PC210-6K — 24.2 WHEN REQUIRED

24. SERVECE PROCEDURE 24.2.7 REPLACE BUCKET TEETH (HORIZONTAL Replace PIN TYPE) the teeth before the wear reaches the adapter. AWARNING It is dangerous if the work equipment moves by mistake when the teeth are being replaced. Set the work equipment in a stable condition, then stop the engine and apply the locks securely to the levers. AN112930 1. Place a block under the bucket bottom so that the pin ( of tooth can be knocked out with a hammer. Carry out full stroke operation of the control levers within 15 seconds after the engine has stopped. After confirming that the work equipment is in a stable condition, lock the safety lock lever.

Set so that the bottom face of the bucket is horizontal. ALO68920 2 Place a bar on the pin head and strike the bar with a hammer to knock out pin @. Remove tooth @®. REMARK Use a round bar with a smaller diameter than that of the pin. AM091360 3. Clean the mounting face. Fit a new tooth @ in the adapter, push in pin @ partially by hand, then lock it with a hammer the tooth to the bucket. to install a ~ F AM091370 3-39