Komatsu PC210-6K — 24.2 WHEN REQUIRED

24. SERVICE PROCEDURE 24.2.8 ADJUST BUCKET CLEARANCE AWARNING It is dangerous if the work equipment the clearance is being adjusted. Set the work engine and equipment moves by mistake when in a stable condition, then stop the lock the lever securely. AN112930 1. Set the work equipment to the position shown right, stop the engine and set the lock in the diagram at lever to the locked position. 2. Shift O-ring @ of the linkage and measure the amount of play (a). Measurement is easier of you move the bucket to one side or the other so all the play can be measured in one place.

CI @ C3 (In the diagram this is on the left-hand side) Use a gap (clearance) gauge for easy and C——_ accurate measure- Bucket ment. 3. Loosen the four plate fixing bolts of @ and loosen plate @). Because it uses split shims, you can carry out the operation without removing the bolts entirely. 4. Remove shim @ corresponding to the amount of play (a) measured above. [Example] In the case of play of 3 mm, remove two 1.0 mm shims and one 0.5 mm shim. Play becomes 0.5 mm. For shim (4), two types of 1.0 mm and 0.5 mm are used. When play a is smaller than one shim, do not carry out any maintenance. 5. Tighten the four bolts @.

If the bolts @ are too stiff to tighten, pull out pin stopper bolt © for easier tightening. 3-40 Arm