Komatsu PC210-6K — 24.5 EVERY 250 HOURS SERVICE

24. SERVICE PROCEDURE 24.5 EVERY 250 HOURS 24.5.1 CHECK OIL SERVICE OIL LEVEL IN FINAL DRIVE CASE, ADD AWARNING e@ The oil is at high temperature immediately after the machine has been operated. Wait for the oil to cool down before starting the operation. @ If there is still pressure remaining inside the case, the oil or plug may fly out. Loosen the plug slowly to release the pressure. e@ Prepare 1. Set the TOP mark at the top, with the TOP perpendicular to the ground surface. 2. Remove plug © using the handle. When the oil level reaches a point 10 mm below the bottom of the plug hole, the correct amount of oil has been added. 3. a handle.

mark and plug ® If the oil level is too low, install plug ©, operate the travel levers, and drive forward or in reverse to rotate the sprocket one turn. Then repeat Step 2 to check again. 4. If the oil level is still too low, add engine oil through the hole in plug © until the oil overflows. NOTICE For details of the oil to use, see "20. USE OF FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE". 5. 3-52 After checking, install plug ©. AN114750