Komatsu PC210-6K — 24.6 EVERY 500 HOURS SERVICE

24, SERVICE PROCEDURE e (1) (2) (3) Normal air bleeding procedure Add fuel to the fuel tank until full (to FULL mark on the fuel gauge). After replacing filter cartridge G), loosen joint bolt @. Loosen the knob of feed pump @), and move it up and down about 50 - 60 times to cause fuel to overflow until bubbles do (4) not come out from the joint bolt any more. Tighten joint bolt @. NOTICE Do not rotate the starting motor continuously for more than 20 seconds. Wait for 1 -— 2 minutes before rotating again. REMARK When the engine stops because of running out of fuel, also operate the feed pump according to the above procedure to bleed air. 24.6.2 CHECK SWING GREASE Prepare 1.

PINION GREASE LEVEL, ADD a scale. Remove bolts G) (2 bolts) on the top of the revolving frame and remove cover @). Insert a scale into the grease and check that the height of the grease in the portion where the pinion passes is at least 28 mm (1.1 in). Add more grease if necessary. Check if the grease necessary to change is milky white. If it is milky white, it is the grease. Please contact your Komatsu distributor. The total amount of grease is 21 2 (18.9 kg) (5.5 US gal, 4.6 UK gal [41.7 Ib]). 4. Install cover @ with bolts @). 3-59