24. SERVICE PROCEDURE 24.6 EVERY 500 HOURS SERVICE Maintenance for every 100 and 250 hours should be carried out at the same time. 24.6.1 REPLACE FUEL FILTER CARTRIDGE AND ADDITIONAL FUEL FILTER CARTRIDGE (OPTION) AWARNING e Engine is at high temperature immediately after the machine has been operated. Wait for engine to cool down before replacing the filter. e Do not bring fire or sparks near the fuel. Prepare a filter wrench and a container to catch the fuel. 1. Set the container to catch the fuel under the filter cartridge. 2. Using a filter wrench, turn counterclockwise to remove it.
filter cartridge @ and @® Clean the filter holder, fill a new filter cartridge (> with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. When installing, tighten until the packing surface contacts the seal surface of the filter holder, then tighten it up 1/2 of a turn. Clean the additional filter holder, fill a new additional filter cartridge @ with clean fuel, coat the packing surface with engine oil, then install it to the filter holder. When installing, tighten until the packing surface contacts the seal surface of the additional filter holder, then tighten it up 2/3 of a turn.
If the filter cartridge damaged and this is tightened will lead to too far, the leakage cartridge is too loose, fuel will also leak from always tighten to the correct amount. After replacing the fuel filter cartridge, packing of fuel. the 3-58 be filter packing, bleed the air. Bleed the air according to the following procedures. will If the so AM32B420